Black plate (191,1)
北
米
Model "A1170BE-C" EDITED: 2014/ 3/ 17
&
Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the
“ ”
position when it
is dark outside.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the following conditions are fulfilled.
.
The engine is running.
.
The parking brake is fully released.
.
The light control switch is in the
“
AUTO
”
(if equipped),
“
”
or off position.
.
For CVT models, the select lever is in a
position other than the
“
P
”
position.
NOTE
.
When the light switch is in the
“
”
position, the instrument panel illumina-
tion, front side marker lights, tail lights
and license plate lights are also illumi-
nated.
.
For models with the auto on/off
headlights, while the light control
switch is in the
“
AUTO
”
position and
the system is activated to the auto-on
mode depending on the ambient light
level, the high beam headlights that
have illuminated at reduced brightness
turn off, and the low beam headlights
turn on alternatively. At this time, the
instrument panel illumination, front
side marker lights, tail lights and
license plate lights are also illuminated.
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The turn signal
indicator lights will flash in the direction of
the turn or lane change. The lever will
return automatically to the neutral position
when you release it.
Instruments and controls/Turn signal lever
3-73
3
