USER MANUAL Safety Matters
- 23 -
Operation preparation before use
Preparation before use
1.
Before using this product, charge the battery till full with the special charger.
When the
five power indicating lights all turn on, the battery is fully charged.
2. You will hear the clicking of the snap joint when you correctly install and fasten the
batteries. Please make sure the battery is firmly installed.
(As shown in the picture below)
3. Check if there is any damage to the exterior shell. If yes, then do not use it
underwater.
4. Push down the two start buttons in the air and test-run the product (for no more than 1
minute) to see if the thruster is operating normally and there is no blocking or noise. Check
the power indicating light and LOGO indicating light are on normally.
Summary of Contents for MIXAB01
