The product includes a mobile phone waterproof case holder, used with phone cases,
allowing phones to shoot photos underwater. The holder can be installed or not
according to your needs.
2
Waterproof Mobile Phone Case Holder
1
4
4
1. Rotate the holder right or left to the horizontal position.
2. Align the two limit bumps
①
of the case holder to
②
the back spacing hole of
the floater. Then insert the screw
③
, tighten it by hand or a screwdriver (as shown
below).
3. Turn the knob nut of the holder
④
counterclockwise to open the clip to a proper
position. Insert the waterproof case with the mobile phone, then tighten the nut
④
clockwise to tight the holder.
2
3
12
13
The product includes a safety leash. One side of the safety leash is connected to the
handle and the other side is connected to the wrist of the same side. The safety leash
can be used to prevent the product from losing due to water flow or other reasons.
Wear and Emergency Release the Safety Leash
3
4. According to your shooting needs, rotate the holder to the horizontal or vertical state.
5. Finally, connect the waterproof mobile phone case to the floater with the phone
case safety leash
⑤.
1. The waterproof case holder can not keep the phone sealed under water. Therefore,
ensure that your mobile phone has independent and reliable sealing protection before
use, and follow the corresponding instructions.
2. Use appropriate force while tightening the nut. Excessive force may damage the
waterproof case or phone, causing trouble and loss.
* The waterproof mobile phone case holder must be used with the floater and is purchased
separately.
5
