6
FurnaCE rEMOVal
To replace parts or service the
SUBURBAN
family of
RV
furnaces, it is necessary to follow these
steps:
DD-17DSI
1.
Turn off gas and power, then disconnect gas and power supply at the furnace. Label wires as necessary.
2.
Remove the vent cap assembly by removing applicable screws.
3.
Remove the cabinet front two (2) screws.
4.
Remove the applicable screws securing the furnace to the coach floor.
5.
Remove duct from side of furnace, if equipped.
6.
Remove the furnace from the cabinet area to gain access to combustion chamber and applicable parts.
7.
Some parts can be accessed without removal of the complete furnace.
8.
To re-install, reverse this procedure.
9.
Rewire applicable wires and perform a leak test on all fittings. Perform a drop pressure test.
NT-12/16/20S
1.
Turn off gas and power, then disconnect gas and power supply at the furnace. Label wires as necessary.
2.
Remove the vent cap assembly by removing applicable screws.
3.
Remove the cabinet front two (2) screws.
4.
Remove the (1) one tie down screw securing the chamber to the cabinet.
5.
Remove the furnace from the cabinet by pulling chamber outward completely to gain access to all controls and
applicable parts.
6.
To re-install, reverse this procedure.
7.
Rewire applicable wires and perform a leak test on all fittings. Perform a drop pressure test.
NT-12/16/20SE
1.
Turn off gas and power, then disconnect gas and power supply at the furnace. Label wires as necessary.
2.
Remove the vent cap assembly by removing applicable screws.
3.
Remove the cabinet front two (2) screws.
4.
Remove the (2) two tie down screws securing the chamber to the cabinet.
5.
Remove the furnace from the cabinet by pulling chamber outward completely to gain access to all controls and
applicable parts.
6.
To re-install, reverse this procedure.
7.
Rewire applicable wires and perform a leak test on all fittings. Perform a drop pressure test.
NT-24/30/34SP and NT-40
1.
Turn off gas and power, then disconnect gas and power supply at the furnace. Label wires as necessary.
2.
Remove the vent cap assembly by removing applicable screws and one (1) flue retaining screw. Not applicable to
NT-40.
3.
Remove the cabinet front two (2) screws.
4.
Remove the (2) two tie down screws securing the chamber to the cabinet.
5.
Remove the furnace from the cabinet by pulling chamber outward completely to gain access to all controls and
applicable parts.
6.
To re-install, reverse this procedure.
7.
Rewire applicable wires and perform a leak test on all fittings. Perform a drop pressure test.
