background image

DOOR MODEL INSTALLED ON RIGHT

1

Remove the paper backing from the tape on the back
of the heater panel.

2

Place the heater on the left side of the unit on the
right.

3

Align the heater with the top of the unit, and press
firmly to secure.

4

Install edge guard on the bottom of the heater panel
where wires pass. Trim the edge guard to fit.

5

Clip the ground wire to the opening and the heater
panel.

6

Remove the screws from the back panel and remove
the back panel.

7

Remove the unused connector.

8

Place the leads from heater into the correct location
on the connector.

Note

: Wire location is model-specific. Refer to the

chart for proper placement.

WIRE PLACEMENT

MODEL

WIRE PLACEMENT

Combination Refrigerator/
Freezer

1 and 2

All Other Models

2 and 4

9

Connect the heater connector to the connector on the
unit.

10

Install the back cover using the existing screws.

11

Install the plastic bushing around the heater wires,
then insert the bushing into the hole on the back
panel.

12

Clip the ground wire to the bottom of the heater and
to the square hole on the back cover.

13

Install tape to the front edge of the heater.

14

For the drawer model only, remove the center
mounting trim and install the new trim provided with
this kit.

Designer Series - Undercounter and Drawers Dual

Installation

subzero.com     800.222.7820

 

 

Page 3 of 4

 

Summary of Contents for AMPLIFIER Series

Page 1: ...anel 2 Place the heater on the left side of the unit on the right 3 Align the heater with the top of the unit and press firmly to secure 4 Install edge guard on the bottom of the heater panel where wires pass Trim the edge guard to fit 5 Install edge guard along the upper edge of the opening and bottom of the heater panel where wires pass Edge guard must be trimmed to fit EDGE GUARD GROUND WIRE 6 ...

Page 2: ...rim and insall the new trim provided with this kit 14 Insert both units into the opening 15 Secure side trim using the clips and screws provided If using a power drill set to the lowest torque setting to avoid stripping the inside of the clips 16 Align the center trim with the clips and press to install Designer Series Undercounter and Drawers Dual Installation subzero com 800 222 7820 Page 2 of 4...

Page 3: ...nnector Note Wire location is model specific Refer to the chart for proper placement WIRE PLACEMENT MODEL WIRE PLACEMENT Combination Refrigerator Freezer 1 and 2 All Other Models 2 and 4 9 Connect the heater connector to the connector on the unit 10 Install the back cover using the existing screws 11 Install the plastic bushing around the heater wires then insert the bushing into the hole on the b...

Page 4: ...and screws provided If using a power drill set to the lowest torque setting to avoid stripping the inside of the clips 17 Align the center trim with the clips and press to install Designer Series Undercounter and Drawers Dual Installation subzero com 800 222 7820 Page 4 of 4 ...

Reviews: