Rev.06
– 03/02/2021
Pag. 13/33
Code: 71207
insert the battery laterally making sure to position it correctly (that the red connector is on the same side as that of
the motor and that the adhesive labels are not positioned upside down);
place the battery on the supports and center it at the rear between the rods (the battery spacers fit perfectly between
the rods);
connect the red connectors.
10.6. CLOSING THE BATTERY COMPARTMENT
Always with the SCOOTER in vertical position, carefully check that the closing OR gasket (19) (fig.2) is inserted in
its seat, cleaned and adequately lubricated with petroleum jelly. Also check the cleanliness of the body seat (20), if
necessary pass a clean microfibre cloth to remove dust or sand. Insert the bow cap (8 - Fig.1) matching the screw
(18) with the hole (17). Turn the handwheel (9) clockwise until it is completely closed without tightening too much
using just the force of two fingers: the position of the handle on the roller must be aligned with the switch (Fig. 2).
11.
CORRECT USE
After the preliminary operations, proceed as follows to start the SCOOTER:
Always make sure that the switch (6 - Fig.1) is in the OFF position,
Immerse the SCOOTER in water and check that there are no foreign bodies between the propeller blades. Otherwise,
with the switch in the OFF position, remove the SCOOTER from the water and free the propeller blades from the
foreign object.
In spite the propeller is equipped with a safety clutch to reduce the risk, using the hands
or other parts of the body is a potentially danger operation.
For this reason absolutely necessary to AVOID TO INTRODUCING HANDS or other
parts of the body, INTO THE PROPELLER zone.
In case access here is needed for cleaning or undesired objects removal, use a stick or
a suitable tool.
Turn the switch (6-Fig.1) clockwise, completely, without forcing.
Grip the handle of the SCOOTER (1) or, if used, hook the carabiner to the towing harness.
Press the trigger (2) until the engine starts.
To stop the propeller, release the trigger (2).
CAUTION:
• By pressing the trigger, the propeller begins to rotate and the SCOOTER begins to
advance;
• When the trigger is pulled, the SCOOTER will not start IF the main switch is turned to
one of two speeds.
To change speed of SCOOTER, turn the knob (7 - Fig1): the vertical alignment of the knob sets the Scooter to OFF.
Turn the selector to the right (as shown in below figure) to drive at moderate speed.
Turn the selector to the left to increase the speed.
A tamplography placed next to the knob summarizes what has just been described.
This speed change can be made at any time, even while diving.
When Scooter is not in use, turn off the main switch (6) by turning it anticlockwise until it turns off.
