3
Leading edge
Leading edge
Open area track
Trailing edge
Connecting side
Connecting side
Connecting side
Door pocket track
Door pocket track
Open area rail
Track end to be
connected
Track end to be
connected
Trailing edge
Connecting side
Track length for open area : Lo
30
200
30
Track length for door pocket :
Lp
30
Track length for door pocket :
Lp
30
Track length for open area : Lo
30
200
30
30
30
20
30
30
20
30
30
20
Track end to be
connected
Track end to be
connected
0
3
0
3
20
I
5.2
I
9.6 CSK
Process holes for track
mounting.
2×
I
5
Process holes for Trigger (leading edge).
2×
I
5
Process holes for Trigger
(leading edge).
When cutting from a long track (1860 mm, 2760 mm, 3960 mm)
When using 1260 mm track
I
5.2
I
9.6 CSK
Process holes for track
mounting.
I
5.2
I
9.6 CSK
Process holes for track mounting.
No use
No use
No use
I
5.2
I
9.6 CSK
Process holes for track
mounting.
1
Cutting Track and Hole Processing
2
Installing Door Pocket Track
Door pocket track
Attached screws
(Cross recessed countersunk
head tapping screws 4 × 40)
Remove any dirt or aluminum chips
from the track.
Assemble the cover panel to the door pocket
after mounting the track.
The end which has three
countersunk holes must
face center.
When cutting, use reinforcer for
the track to prevent deformation
at cut section.
(This manual explains assembly procedures for single side
sliding system.)
C o n f i r m a t i o n
b e f o r e a s s e m b l y
・
Check that dimensions of frame, floor, door and track are
correct.
・
Check that frame and floor are not inclined.
・
Check that door is processed correctly.
・
Check that door is not warped.
・
Check that all parts are prepared.
Remove any dirt or aluminum chips from the track as they would damage the rollers and cause noise during operation.
ASSEMBLY
