4
3
5
Preparation of Mounting Parts
4
Installation of Casing and Door Guide Track
Installing Pocket Trigger
6
Confirmation Before Installing Two-way Soft Closer
Pocket trigger
Insert this end which has
the pin.
Main ain unit
Pull up
lever
Pull out casing
Pay attention to the direction.
If the closer is installed without conformation,
it will cause the trouble such as no-sliding of door.
Pull up lever to separate main unit from casing.
Fix the casing with attached screws firmly.
Correct set position
Trigger catcher
Correct set position
I
6
If the position is wrong, pull back the trigger catcher to
the correct position using 6mm diameter hard bar.
Incorrect set position
7
Assembly of Psrts for Open Area Track.
Assemble the parts in order of
to
with care of direction.
You can insert the parts smoothly from the connecting end which has no burr.
1
3
Front trigger
Upper roller
Two-way Soft Closer
Pay attention to the direction.
1
2
3
Open area track
The edge which has three countersunk
holes is the end to be connected.
Slot for Trigger
Slot for Soft Closer,
Roller
Remove any dirt or aluminum chips from
the track.
Tape around upper roller and
upper track to prevent inserted
parts from moving.
Leading edge
Connecting side
OK
Casing
Door guide track
1
2
3
Door pocket track
8
Caution
(Red colored Part)
Insert it until it is
hidden by the track.
