Suhr A.C.E, User Manual

5

Inputs & Outputs

INPUTS

LINE:

This input is for line level signals only.

NOTE:

When using the line input, the INPUT level control is bypassed. Use 

a signal cable for connections.

FROM AMP:  

This input is for Amplifier Level signals. The output of an am

-

plifier can be plugged into this input while the amp is loaded by a suitable 

load, such as a speaker cabinet or a Suhr Reactive Load. The load can 

be connected to the 

TO SPEAKER

 input, which is connected in parallel to 

the 

FROM AMP

 input. The load can also be connected in parallel with the 

A.C.E. if the amplifier has multiple available outputs.

TO SPEAKER:  

This input is a through connection from the 

FROM AMP

jack to allow the connection of a suitable load or speaker cabinet.

NOTE:

When using the FROM AMP / TO SPEAKER jacks, use a speaker 

cable for connections.

OUTPUTS

BALANCED:  

The balanced XLR output is a low impedance 

line level

 out-

put. 

UNBALANCED:  

The unbalanced output is a low impedance 

line level

 out-

put. Use a mono 1/4” phone jack for this output.

Tip:

 The BALANCED output is the preferred output when driving long cable 

lines. Balanced signals have the benefit of rejecting injected noise from the 

environment.