Suhr Hombre, User Manual

9

Rear Panel

This section will explain the speaker outs and the rear panel of the Suhr 

Hombre�

Steps:  

1� Connect the MAINS INPUT with the include power cable.
2� Connect Hombre’s internal speaker (or primary cabinet) to the red jack  

labeled Speaker using a 1/4” speaker cable.

3� Optionally connect a second speaker cabinet to the EXT SPKR jack  

using a 1/4” speaker cable.

4� Turn on the POWER switch to turn on Hombre�

IMPORTANT NOTE: While the amp is optimized for an 8Ω load, it's 

rather forgiving with impedance mismatches. Hombre may be safely 

operated with a 4Ω or 16Ω load, however, the overall efficiency of the 

amp may be slightly reduced.

!

!

Rear panel section (left)

Rear panel section (right)

IMPORTANT NOTE: While the speaker outputs are in parallel, they are 

also prioritized. This means the output with the red ring that’s labeled 

“SPEAKER” must be connected before the "EXT SPKR" jack will func-

tion. Simply put, If you are using one speaker cabinet, use the output 

with the red ring, labeled "SPEAKER".

!

!

IMPORTANT NOTE: The two speaker outs are also wired with a load 

protection circuit which will cause the fuse to blow if no load is 

connected. This is to protect your amps output transformer.

!

!