Rate:
Set the Rate control for the desired modulation rate
from 1Hz to 20Hz.
Depth
:
Set the Depth control from 0% to 100% for the desired
amount of the effect.
Waveform
:
Select a modulation waveform - Square Wave, Sine Wave,
Triangle Wave, Reverse Ramp, or Ramp.
Level
:
Set the desired output level.
Subdivision
:
Set the 3-position switch to subdivide the tempo into quarter notes,
eighth notes, or quarter note triplets.
FxLink:
If an external cable is plugged in, the pedal will power up into the
state dictated by the FxLink jack.
(Note: If external control is desired, the
switch MUST be set to the center position. To have the effect engaged at power
up, set the slide switch toward the Power jack. To have the effect off at power
up, set the slide switch toward the FxLink jack.)
True Bypass:
True bypass can be defeated, allowing the pedal to be used as a
buffer by switching the internal True Bypass switch. Remove the
cover and set the switch located between the 1/4" jacks. Note the
nomenclature printed on the circuit board.
True Bypass is toward the input jack, whereas Buffered mode is
toward the output jack.
LED:
In normal operating mode, the LED color is green. When Tap
Tempo is selected, the LED color will be orange. In strum tempo
mode, the LED color will be red.
