Boost:
(Located on Back)
Provides a Post-EQ boost in gain to the output section for more saturation while leaving the pre-amp clean and
punchy.
NOTE:
Boost function requires a latching on/off foot switch to activate.
Stand-By:
(Located On the Back)
With the Power switch in the OFF position and the Standby switch in the Standby position, flip the power switch to
ON. Wait sixty seconds, then flip the Standby switch to the ON position*. To power down, switch the power switch
to the OFF position.
*This will extend tube life.
NOTE:
To avoid loud popping or damage, ensure the amplifier is in the Standby position.
Tubes:
The Single Channel tube compliment consists of four 6V6 power tubes,
three 12AX7 and one 12AT7 preamp tubes.
