Section 3
SPECIFICATIONS
14
MOTOR: (24KT AND STANDARD COMPRESSORS)
Type
30HP
Size
60Hz, 3 Phase, ODP, 460V, A.C. 40
_
C Maximum Ambient Temperature
Options: 200V to 230V and 575V
TEFC Also Available
Speed
1800RPM
Starter
460V Magnetic Full Voltage
Options: 200V to 230V and 575V
Shaft Diameter
1
%
@
8
” (41.3mm)
Type
40HP
Size
60Hz, 3 Phase, ODP, 460V, A.C. 40
_
C Maximum Ambient Temperature
Options: 200V to 230V and 575V
TEFC Also Available
Speed
1770RPM
Starter
460V Magnetic Full Voltage
Options: 200V to 230V and 575V
Shaft Diameter
1
&
@
8
” (47.6mm)
FOR 50 HZ COMPRESSORS
Type
25HP
Size
60Hz, 3 Phase, ODP, 380V, A.C. 40
_
C Maximum Ambient Temperature
Speed
1500RPM
Starter
380V Magnetic Full Voltage
Options: 415V
Shaft Diameter
1
%
@
8
” (41.3mm)
Type
30HP
Size
60Hz, 3 Phase, ODP, 380V, A.C. 40
_
C Maximum Ambient Temperature
Speed
1500RPM
Starter
380V Magnetic Full Voltage
Options: 415V
Shaft Diameter
1
%
@
8
” (41.3mm)
Type
40HP
Size
50Hz, 3 Phase, ODP, 380V, A.C. 40
_
C Maximum Ambient Temperature
Options: 415V
TEFC Also Available
Speed
3000RPM
Starter
380V Magnetic Full Voltage
Shaft Diameter
1
%
@
8
” (41.3mm)
LUBRICATION
GUIDE--STANDARD
COM-
PRESSORS
Sullair standard compressors are filled with SRF
1/4000 fluid as factory fill.
WARNING
!
Mixing of other fluids within the compressor will
void all warranties.
SRF 1/4000 fluid should be changed every 4000
hours or once a year, whichever comes first. The
fluid should be changed more frequently under se-
vere operating conditions, such as high ambient
temperatures coupled with high humidity, or when
high particulate level, corrosive gases or strong oxi-
dizing gases are present in the air.
For extended life synthetic lubricants contact the
nearest Sullair representative.
Maintenance of all other components is still recom-
mended as indicated in the Operator’s Manual.
LUBRICATION GUIDE--24KT COMPRESSORS
Sullair 24KT compressors are filled with a lubricant
which normally does not need to be changed. In
the event a change of fluid is required, use only Sul-
lair 24KT fluid.
WARNING
!
Mixing of other lubricants within the compressor
unit will void all warranties!
Sullair recommends that a 24KT sample be taken
at the first filter change and sent to the factory for
Summary of Contents for 10B 25HP
