6.5 FLUID FILTER MAINTENANCE
Refer to Figure 6-1. Replace your fluid filter element under
any of the following conditions, whichever occurs first:
1. As indicated by the WS Controller.
2. Every fluid change.
Fluid Filter Element Replacement
Refer to Figure 6-1.
1. Using a wrench, remove the filter canister.
2. Remove and dispose of filter element. Observe all
laws and regulations for filter disposal.
3. Clean gasket seating surface.
4. Apply a light film of fluid to the element seal.
5. Install the element into the filter canister.
6. Screw the canister to the filter head. Tighten to 10 to
12 ft·lb. (13.5 to 16.0 N·m)
7. Restart compressor and check for leaks.
3
2
1
SU_0000029
1. Filter Head
2. Element*
3. Body
Fluid Filter:
02250156-599
*Fluid Filter Repair Kit:
02250156-601
Figure 6-1: Fluid Filter Assembly
6.6 AIR FILTER MAINTENANCE
Refer to Figure 6-2. Air filter maintenance should be
performed when the maintenance gauge shows red with
the compressor running full load, or once a year,
whichever comes first. If the filter needs to be replaced,
order a replacement element. Below you will find
procedures on how to replace the air filter element.
1
2
3
4
SU_0000030
1. Housing
2. Clamp
3. Element*
4. Cover
Air Filter:
02250125-370
*Replacement Element:
02250125-365
Figure 6-2: Air Filter Assembly
Air Filter Element Replacement
1. Pull the yellow latch to release the cover.
2. Clean exterior of air filter housing.
3. Rotate end cover counterclockwise and remove
4. Remove air filter element by pulling it out of the
housing.
5. Clean interior of housing using a damp cloth. DO
NOT blow dirt out with compressed air.
6. At this time replace the element.
7. Reassemble in the reverse order of the disassembly.
SECTION 6
40
1100e, 1500e, 1800e Operator’s Manual and Parts List
®
SULLAIR
®
Summary of Contents for 1107e
Page 101: ...THIS PAGE INTENTIONALLY LEFT BLANK...