Section 9
ILLUSTRATIONS AND PARTS LIST
83
9.16 DISCHARGE SYSTEM - 300-450HP/224-336KW WITH SWING LID
key
part
number
description
number
quantity
1
connector, flex 1/4t x 1/4p
020169
4
2
probe, rtd 100 ohm plat 6”x 20ft
(I)
02250058-087
1
3
plug, sight glass 1-7/8” sae
02250097-611
1
4
flange, kit sae splt 3” - viton
02250100-926
1
5
connector, tube male bhd 1/4 x sae
02250101-490
1
6
sleeve, rtd ls20-100 out housing
02250116-089
1
7
filter, assembly genisis filter
(II)
02250117-782
2
8
valve, ball 3/4” npt apollo
02250117-792
1
9
element, sep/pri ls20ts 500#
(III)
02250119-666
1
10
element, sep/sec ls20ts 500#
(III)
02250119-667
1
11
gasket, sep ls20ts 16” flange
(IV)
02250121-188
1
12
adapter, discharge vlv m85 ddh204 hp
02250124-030
1
13
orifice, plug brass 1/8”npt x 1/32”
02250125-774
1
14
orifice, plug brass 1/8”npt x 3/32”
02250125-776
1
15
sightglass, orf block sae
02250126-129
2
16
valve, assy 3”x m85
(V)
02250127-507
1
17
nut, hex m85-2 6h
02250130-997
1
18
plate, scav line assy - ls20t
02250132-464
1
19
valve, relief 1” npt 400psi
02250137-688
1
20
sleeve, rtd 1/2”npt ls20t disch
02250138-457
1
21
pipe, discharge assy ls20ts 350#
02250139-146
1
(I)
For maintenance on rtd probe no. 0225058-087, order replacement probe no. 02250058-087.
(II)
For maintenance on assembly filter no. 02250117-782, order replacement assembly no. 02250117-
782.
(III)
For separator maintenance, order primary element replacement kit no. 02250122-833, and secondary
element replacement kit no. 02250122-832.
NOTE:
Replacement cover gasket (no. 0220121-188) is
included with primary element replacement kit.
(IV)
Separator cover gasket must be replaced if the sump lid needs to come off, whether for maintenance
or not. Whereas a replacement gasket comes with the primary element replacement kit, gasket no.
02250121-188 can be ordered separately for non-maintenence occasions.
(V)
For maintenance on assembly valve no. 02250127-507, order repair kit no. 606208-001.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE THE SERIAL NUMBER OF COMPRESSOR
Summary of Contents for LS20T 1100 CFM
