TS32 USER MANUAL
SECTION 4
60
P
IPE
S
IZING
Pipes should be sized as a minimum to match the
dimensions of the compressor’s discharge
connection. All piping and fittings should be rated for
the discharge pressure.
A
UXILIARY
R
ECEIVER
T
ANK
An Auxiliary receiver tank should be installed in
systems where large demand fluctuations will occur.
I
SOLATION
V
ALVES
Install isolation valves where isolation of the
compressor from the service lines is required. These
valves should have drip legs that drain at an angle
downward from the base. A vent to the piping should
be installed downstream of the compressor outlet
connection.
When two compressors are installed to operate in
parallel with a common receiver tank, an isolation
valve and drain trap for each compressor should be
installed before the common separator/sump.
Compressors have built-in aftercoolers and are
equipped with a condensate drain located next to the
air outlet connection. A drain line should be installed
to remove the condensate, which builds up during
compressor operation. See
.
Figure 4-1: Typical Service Air Piping
NOTE
Compressors not equipped with an auxil-
iary receiver tank may need to have their
response times adjusted. Contact Sullair
Customer Care for assistance.
Summary of Contents for TS32 AC
