21
CoMPoNENT DESCRIPTIoN
3.11
INSTRUMENT PANEL
The instrument panel contains all the necessary controls and instrumentation for operation. It is
conveniently located curbside, and enclosed by a lockable, hinged door. Following is an explanation of the
principal controls and instruments:
0
50
100
150
200
250
300
Figure 3-5.
05018845 0166 PANEL, INST SINGLE PSI (REV 00)
ITEM NAME
DESCRIPTION
1
Discharge Air Pressure Gauge
Displays discharge air pressure of compressor.
2
Sullivan-Palatek Electronic
Controller (SPEC)
Monitors the engine and compressor parameters, displays warning and
shutdown information, and displays engine diagnostic information from
the engine ECU.
3
Ignition Switch
START
position electrically energizes engine starter motor solenoid.
4
Start-Run Switch
START
allows compressor to be started.
RUN
allows full-load operation.
3.11.1 COMPRESSOR DISCHARGE PRESSURE GAUGE
The compressor discharge pressure gauge indicates the discharge air pressure. Normal operating pressure is
90 to 115 psig for low pressure compressors, and/or 90 to 150 psig for high pressure compressors.
Summary of Contents for D260UJD4PTOW
