30
INSTAllATIoN AND oPERATIoN
4.9
SULLIVAN-PALATEK ELECTRONIC CONTROLLER (SPEC) OPERATING
INSTRUCTIONS
The buttons for operation will be referred to
numerically based upon the image at right.
Button functionality can vary depending on the
operator input required for each page. Pages
requiring custom button functionality will display
button function icons directly above the buttons.
HOME PAGE
The Home Page screen shows current engine and
compressor conditions. Additional warnings are
displayed within the RPM gauge.
Buttons 1 and 5 cycle between the main screen and
the replacement parts list;
Buttons 2 and 4 adjust the display contrast,
2 being darker and 4 being brighter;
button 3 is the Main Menu button. It activates the
Main Menu pop-up, shown below.
MAIN MENU
On the Main Menu pop-up:
buttons 1 and 2 cycle between the selections;
button 3 returns back to the home Page;
button 4 will display any faults;
Button 5 enters into the option selected with
buttons 1 and 2.
Each pop-up menu item description follows:
ENGINE DIAGNOSTICS MENU
Diagnostic messages and fault codes will be listed
here.
buttons 2 and 4 cycle between fault codes;
button 3 returns back to the home Page;
button 5 refreshes the list of faults.
Summary of Contents for D260UJD4PTOW
