Cyclo® BBB5
24
Operation & Maintenance Manual
Cyclo® BBB5
Y2 Oil Fill & Drain Procedures,
continued
Oil Drain Process
Oil Drain Process
CAUTIONARY NOTE:
• Exercise extreme caution when draining the lubricating oil from the Cyclo® Bevel Buddybox® as it may be hot.
• Follow all corporate, local, state and federal government regulations in disposing of the used lubricating oil.
1
Identify the bevel portion oil drain plug on the bevel gear housing .
Carefully remove the plug and put aside for reinsertion after oil fill is complete .
2
Carefully remove the unit air breather assembly and put aside for reinsertion after oil
fill process is complete .
Allow used oil to freely flow into an approved lubricant container .
Once the unit is completely drained of oil, reinstall the drain plug and tighten .
Refer to torque tightening values in Table 19 .
Table 19 . Plug sizes and tightening torque values
Plug Sizes
Torque Value
Unit Size
Housing*
Size
lb-in
N•m
5Z
1/2
1/2
13:1
17 .8
5A
1/2
3/4
22:1
30 .0
5B
6x 1/2
1
30 .4
41 .2
1x 1
5C
6x 1/2
1x 1
* 5 series is a monoblock and does not have separate casing .
In the event that
the lower plug is
covered with a
bolt on foot, this
plug may be used
as a drain
