Cyclo® HBB
Operation & Maintenance Manual
43
Cyclo® HBB
Cyclo® Portion Disassembly/Assembly
Cyclo® Disassembly and Reassembly Procedures
14
Remove the
high speed shaft
, along with its associated
bearing
, from the
high
speed end shield
High Speed Shaft
Bearing
Cyclo Reassembly Procedure
The Cyclo® portion of the speed reducer may be reassembled by reversing the disassembly procedure All parts must be returned to the
original order from which they were removed during disassembly. Take care to keep the moving reduction components free of dust or foreign
material, and properly align all gaskets in order to keep the assembly oil tight/leak free.
Remember these important notes when assembling the Cyclo® reducer:
1
Place the
ring gear housing
on the Cyclo®
high speed end shield
(or the motor
flange) and insert the ring gear housing
pins
and
rollers
(if they had been removed
during the disassembly process) Rotate each of the pins and rollers by hand to
assure that they freely move/rotate
If the Cyclo® portion of the HBB is grease lubricated, liberally apply grease to the ring
gear pins and rollers before they are inserted into the ring gear housing
2
Cycloid discs
are a matched pair Each disc has the same code etched on one side
When inserting these discs into the ring gear housing, be sure that the etched
number is facing up
Pin
Roller
Summary of Contents for Cyclo HBB
Page 1: ...0 7 6 0 1 6 0 0 0 3 H B B O M2 0 1 8...
Page 27: ...MA X MI N...
