53
52
8. Daily Inspection and Maintenance
■
FB-10E, FB-15E (Indoor Type)
Code
Part Name
1
Stationary core
2
Brake release
3
Seal washer
4
Manual release prevention
spacer
5
Brake release bolt
6
Stud bolt
7
Adjusting washer
8
Spring washer
9
Gap adjusting nut
10
Brake lining
11
Leaf spring
12
Boss
13
Shaft-retaining C-ring
14
Cover
15
Shaft-retaining C-ring
16
Fan
17
Fixed plate
18
Armature plate
19
Spring
20
Electromagnetic coil
21
Ball bearings
22
Motor shaft
23
Bearing cover
-
Gap Inspection
(1)
Remove the brake release bolt [5] and the manual release prevention spacer [4].
(2)
Remove the cover [14].
(3)
Insert a gap gauge between the stationary core [1] and the armature plate [18]
and measure the gap. Measure in 3 locations around the circumference.
(4)
Adjustment is required if the gap value is near the limit.
-
Gap Adjustment
(1)
Remove the brake release bolt [5] and the manual release prevention spacer [4].
(2)
Remove the cover [14].
(3)
Insert a gap gauge between the stationary core [1] and the armature plate [18] and rotate to the right the gap adjusting nuts
[9] that are attached to ends of the stud bolts [6]. If large adjustments to the gap are not possible, decrease the number of
adjusting washers [7]. There are 3 adjusting nuts [9]. Adjust these in turn so that 3 positions on the circumference are uniformly
at the required gap.
(4)
Turn the power on and off to check brake action.
(5)
Attach the cover [14].
(6)
Finally, attach the brake release bolt [5] and the manual release prevention spacer [4].
Gap value G (mm)
Required value
(original value)
Limit value
0.35 – 0.45
1.2
1
2
3
4
5
6
7
8
9
10
11
12
13
14 15 16 17 18 19 20 21
Ｇ
22 23
Figure 8-14
