Installation
24
3.
Inspect for Visible Damage of Compressor Unit.
3.1
Inspect the exterior panels of the Compressor Unit for evidence of damage.
3.2
If there was external damage to the compressor, remove the compressor unit panels
and check for internal damage. Notify the carrier immediately and take photographs
of the damage to document your claim to the carrier.
3.3
If any irrecoverable damage is found (e.g. oil Leakage, panel deformation), contact
the nearest SCAI Service Center.
Compressor Location
Place the compressor in a location that is protected from the elements and where the ambient
temperature will always be within the range of 4° C to 40° C (40° F to 104° F).
The compressor must be installed base down, within 5 degrees of horizontal, and preferably at
a height convenient for making connections and reading the pressure gauge.
Allow 600-mm (24”) space in front of the compressor for access to electrical, water and gas
connections. Allow 600-mm (24”) on the left side (when facing the front) of the compressor for
maintenance of the adsorber.
Electrical Supply Connection - Field Wiring Instructions
Tool required: #3 Phillips screwdriver
5 mm Hex driver
The F-20L compressor must be installed in a circuit capable of supplying the specified voltage
and power. The wiring method used for connection to the front panel power connector must
meet applicable codes.
AVOID ELECTRIC SHOCK.
All electrical supply equipment must meet
applicable codes and be installed by qualified personnel. Permit only qualified
electrical technicians to open electrical enclosures, to perform electrical checks
or to perform tests with the power supply connected and wiring exposed. Failure
to observe this warning can result in serious injury or death.
Connect mains power supply cable into the mains power receptacle on the front panel and
fasten cover with attached screws. See Figure 4 below.
Summary of Contents for F-20L
