32
Compressor Shipping Preparation
PREVENT EQUIPMENT DAMAGE.
Do not over tighten the shipping bolt.
PREVENT EQUIPMENT DAMAGE.
Always thoroughly drain the coolant from
the cooling circuit if the compressor is to be shipped or stored.
A shipping bolt, P/N 70498, was installed on the compressor when it left the factory. If the
compressor is to be shipped, reinstall the shipping bolt from the bottom of the compressor’s
base panel to restrain the compressor during shipment. Hand tighten the bolt until it bottoms.
Use a 17-mm wrench to tighten the bolt 2½ turns.
Return the compressor using the original shipping container or reuse the packaging from a
replacement compressor.
Summary of Contents for HC-4E1
