L3214 Laser Cutter
User’s Manual
Maintenance
35
4.1.1.1
Cleaning the static mirror
1.
Remove the left-hand side cover of the laser cutter using a cross key to gain access to the
static mirror
.
2.
Apply a small amount of IPA optical cleaning solution onto the cleaning cloth provided in
the tool kit and clean the mirror while in position. Ensure not to adjust the mirror position
or apply too much pressure to the mirror so the bracket does not move out of alignment.
4.1.1.2
Cleaning the travelling mirror
The travelling mirror is firmly attached to the Y-axis arm in front of the laser cutting system.
1.
Apply a small amount of IPA optical cleaning solution onto the cleaning cloth provided in
the tool kit and clean the mirror while in position. Ensure not to adjust the mirror position
or apply too much pressure to the mirror so the bracket does not move out of alignment.
