S CLASS™ 2 cutter
User’s Manual
Specifications
6-4
6.2.3
Knife, pen and pouncing tool
The S CLASS 2 cutter comes equipped with all the tools necessary to start working
immediately.
Some tools are pre-installed, while others are packaged in separate boxes.
Below is a table that specifies which tools are delivered with the cutter. Please make sure
that all tools are included with the cutter
.
Medium
Drag
Tangential
Standard drag knife
Standard vinyl
2
1
Sandblast drag knife
(requires sandblast
knife holder)
Sandblast and thicker soft
materials max 0.8mm
x
x
Standard tangential knife
Standard vinyl
x
2
Sandblast tangential knife
(requires
special sandblast nose piece)
Sandblast and thicker soft
materials max 1.2 mm
x
1
Fiber type plotter type pen
Paper
1
x
Ball point pen
(requires ballpoint
penholder)
Paper
x
1
Pouncing pin
Paper
1
1
Razor blade for cut sheet
Standard vinyl up to 0.25mm
(0.03”) thick
2
2
FIG 6-3
6-3
S CLASS 2 TOOLS
To order replacement knives, pens and/or pouncing tools, contact your local Summa dealer,
quoting the part numbers listed in table 6-8 to 6-10.
NOTE:
The S CLASS 2 cutters will only perform according to specifications if a
genuine Summa knife, pen or pouncing tool is installed. Do not replace the
standard knife, pen or pouncing tool with products from other manufacturers.
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
