S CLASS™ 2 cutter
User’s Manual
Setup
1-7
1.2.2
The Cutter as viewed from the back
FIG 1-11
1-11
S CLASS 2 CUTTER, REAR VIEW
1.
AC power cord receptacle:
It is located at the left-hand side of the power entry
module. The power-up procedure is explained in detail in section 1.3. Always use a
power cord that was delivered with your cutter.
2.
Power On/Off switch:
This rocker switch, in the middle of the power entry module, sets
the cutter’s power to ON or OFF. To switch on the power, press the “I” side of the rocker
switch. To switch off the power, press the “O” side of the rocker switch.
3.
The fuse box:
The fuse is located at the right side of the power entry module. Check the
specification section to see which fuse is used in the S CLASS 2 cutter.
WARNING:
For continued protection against risk of fire, replace only with the
same type and rating of fuse.
4.
USB port type A female:
For plugging in a USB stick.
5.
Ethernet port RJ45:
For connecting the cutter to the LAN.
6.
USB port Type B female:
This interface is based on the standards, specified in the
Universal Serial Bus Specifications Revision 1.1. It allows a high-speed bi-directional
communication between the host computer and the cutter.
7.
Pinch roller lever:
This lever is used to raise and lower the pinch rollers for media
loading.
8.
Roll media guide bushes:
The two flange guides serve to keep the media roll in place
when media is pulled from the roll.
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
