S CLASS™ 2 cutter
User’s Manual
Setup
1-10
1.3.1.3
Safety precautions
WARNING:
The S CLASS 2 cutters use razor-sharp knives. Touching the knife
with bare hands may cause injury. Do not touch the knives while the machine is
cutting.
The cutter comes with a tool to insert the knives in the knife holder. Use this tool to prevent
injury. Put used blades in their original packaging for disposal.
The entire base plate should be considered as a dangerous area when the cutter is switched
on and off. The tool carriage can move from the left to the right and the yellow media
sleeves are sharp and can grab loose objects, clothing or body parts.
The cutter constantly measures the current through the motors. If the machine detects the
current is too high, then the current will be cut off to the motors and a fatal error message
will be displayed on the control panel.
Make sure to observe all the caution labels on the cutter.
1.3.2
Operating environment
Environmental conditions can significantly affect the machine’s performance.
The environmental conditions of the machine (without media) are as follows:
Operating Temperature
15 to 35
°
C
59 to 95
°
F
Storage temperature
-30 to 70
°
C
-22 to 158
°
F
Relative humidity
35 - 75 %, non-condensing
35 - 75 %, non-condensing
It is possible that the environmental conditions of the used media are stricter than those of
the machine itself. Please refer to the documentation about the used media.
Moreover, make sure that the media has had enough time to acclimatize.
NOTE:
Keep the cutter away from direct sunlight or a strong indoor light source.
The optical sensors in the machine may be affected, thus causing unexpected
behavior of the cutter.
WARNING:
There is a risk of injury from being caught or trapped in moving
machine parts.
Keep hands, hair, clothing and jewelry away from moving parts. Do not wear
jewelry, loose clothing, scarves, open jackets or shirtsleeves.
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
