S CLASS™ 2 cutter
User’s Manual
Setup
1-28
Installing the drag knife
1.
Remove the aluminum part from the plastic knife holder (5) by turning the knurled
adjustment knob (3) counterclockwise until the aluminum part comes out of the holder.
2.
Insert the conical, non-cutting end of the knife into the opening in the narrow end of
the holder. Gently push the knife all the way in.
3.
Turn the holder upside down and tap it lightly on a solid surface to ensure that the knife
is completely inserted.
4.
Slowly turn the knurled knob clockwise until the tip of the blade extends the distance
required for the desired cutting media (t), as shown in the figure below.
FIG 1-25
1-25
KNIFE LENGTH ADJUSTMENT
5.
Insert the knife holder into the rear (1) of the dual head clamp, seating it firmly.
FIG 1-26
1-26
DUAL CLAMP DRAG HEAD
6.
Close the clamp and tighten the clamp screw.
1 is the position for knife and pen.
2 is the position for a pouncing tool (see section 1.7.1.3).
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
