S CLASS™ 2 cutter
User’s Manual
Setup
1-29
Setting the knife depth and pressure:
WARNING:
Each keystroke can initiate an internal test or movement of the
head or media. Keep fingers and other body parts away from the cutting area.
There are hazardous moving parts.
1.
Power on the cutter and load the media.
2.
Press on pressure
3.
Press the arrow up or
down to change the value.
4.
Or fill in the new value
after pressing Numpad.
1.
Press
to perform the internal knife pressure test.
2.
Press
to confirm the chosen knife pressure and exit the menu.
3.
Press
to leave the pressure unchanged.
Once
is pressed, the current knife pressure value will be set automatically to the
new value and the cutter will cut the knife pressure test pattern.
FIG 1-27
1-27
KNIFE PRESSURE TEST PATTERN
Peel out the rectangle and inspect the media backing.
The knife depth is set correctly when the test pattern cuts completely through the vinyl.
and the blade tip visibly scratched the front side of the media backing when the vinyl is
removed. The blade should never cut in the backing but should only slightly scratch the
silicon coating and first few fibers of the backing material. Because the knife pressure
setting depends on the thickness and type of the media, adjusting the knife pressure will
require some practice. In general, the knife depth must be increased when using thicker
types of vinyl and decreased when using thinner types of vinyl.
NOTE:
After setting the cutting depth and/or the knife pressure, perform a
thorough visual check of the knife blade, protruding from the knife holder and
test the cutting results on a scrap of vinyl media.
WARNING:
Do not operate the cutter if the knife blade cuts through the media
backing, as this will seriously damage the cutter's rubber cutting strip and the
knife.
Knife pressure
95 gr
Velocity
800 mm/s
Tool
Tangential knife
Media size
50000 x 718 mm
Actions
Settings
Configuration 1
Pause
Origin
Summa USB port 1
Cancel
Apply
Test
Numpad
Old value: 85gr
New value: 95gr
Range: 0 ... 600gr
Summa USB port 1
Apply
9
▌
Summa USB port 1
Test
Apply
Cancel
Test
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
