S CLASS™ 2 cutter
User’s Manual
Basic Operation
2-11
However, if the test cut resembles the pattern below, increase the value of the lateral
parameter to correct the closing cut lines.
Longitudinal correction
Weed (remove) out the rectangle and, if you obtained a pattern like the one below,
decrease the value of the longitudinal parameter to correct the closing cut lines.
However, if the test cut resembles the pattern below, increase the value of the
longitudinal parameter to correct the closing cut lines.
Each time a parameter is changed, press
to perform the internal knife calibration test.
NOTE:
Failing to set the knife parameters correctly will result in poor cut quality.
Test
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
