S CLASS™ 2 cutter
User’s Manual
Contour Cutting
3-5
3.2.4
Orientation
Minding the orientation is very important when loading the printed media for contour
cutting. With some cutting software, it may be necessary to collectively rotate the contours
and marks, so that the origin mark (1) is situated in the bottom left corner of the cutting
area (2), as viewed on the screen. If the cutting software’s default orientation is not set to
“landscape,” the contours and marks will need to be rotated.
Orientation needed in most cutter software.
Orientation when using WinPlot
Make sure that the cutter is connected to the computer and that the cutter is switched on.
The cutter’s touch screen should indicate the cutter is ONLINE.
Click Cut from within the cutting software. The cutter should begin cutting the contour and
return to the ONLINE status when finished.
1
2
1
2
NOTE:
Mind the orientation when working from a roll or a sheet. If a complete
roll is printed, then the jobs are loaded “upside down” into the cutter. Check the
orientation before starting to cut.
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
