S CLASS™ 2 cutter
User’s Manual
Detailed Operation
4-10
Long Vectors:
Some vinyls have the tendency to buckle when large designs (long vectors) are cut out. To
avoid this, the speed needs to be reduced. This option does this automatically, so the speed
and acceleration of small vectors are not affected when the speed is reduced.
Press the Long vectors button, then set it to Automatic or Constant velocity.
Press
to confirm or
to cancel. The velocity for long vectors is default set to
automatic.
TurboCut:
TurboCut
increases throughput without raising the overall speed of the plotter by
speeding up the drag movement. The cutting time reduction is significant, especially when
cutting small, detailed designs. However, some thicker materials might not be cut properly
when this feature is activated.
Press the Long vectors button to set it On or Off.
Press
to confirm or
to cancel.
4.3.1.9
General
Media sensor:
The
Media sensors
detect whether media is loaded and also detect the end of the media.
The sensors prevent damage to the cutting strip and knife tip. The sensors can be activated
or deactivated with this menu.
When the sensors are activated, the cutter searches for the front end of the media during
the loading procedure. If it does not find it after returning the media for 1m (+/- 3 feet), it
stops returning the media and sets the origin in the X-axis.
The cutter will also stop during the loading procedure or while it is cutting if the rear sensor
detects the end of the media.
The cutter does not search for the front end of the media and assumes that the loaded
media is endless if the sensors are not activated.
Press the media sensor button, then select to activate (ON) or deactivate (OFF) both or only
the front sensor (FRONT OFF).
Press
to confirm or
to cancel. The default setting for the media sensors is ON.
Recut offset:
The
Recut offset
submenu is used to set or modify the distances between the jobs when
making multiple recuts.
Press the Recut offset button, then set it to the desired value.
Press
to confirm or
to cancel. The default value is 40mm.
Apply
Cancel
Apply
Cancel
Apply
Cancel
Apply
Cancel
Summary of Contents for S Class 2 OPOS-CAM
Page 1: ...User s Manual Rev 3b...
