S One
User’s Manual
Basic Operation
2-13
ATTENTION:
It is difficult to give the recommended settings for FlexCut. Check
section 2.6.2.2.
NOTE:
FlexCut parameters are always metric, regardless of the value of the menu
Units parameter.
ATTENTION:
When cutting through, it is recommended that parallel lines are at
least 1 cm (0.4”) away from each other. Otherwise, while cutting the second line,
the first line may come loose and cause trouble.
7.
Press
to confirm
FlexCut settings.
8.
Press
to go back to
main menu.
9.
Press settings.
10.
Press Panel.
11.
Press Panel size.
12.
Change the value by
pressing the arrows or just
fill in the value.
13.
Press
to confirm
Panel settings.
14.
Press to
return.
NOTE:
Recommended settings for
Panel size
: 3-10 cm.
Flex pressure cut length
1 2 3 0
4 5 6 .
7 8 9 C
1.000
1.000
mm
Full pressure
Full pressure cut length
Flex pressure
Flex pressure cut length
FlexCut mode
FlexCut Velocity
FlexCut
Knife pressure
Knife offset
FlexCut
Tool
Actions
Settings
Knife offset
FlexCut
Tool
Velocity
OptiCut
Panel
TurboCut
Overcut
Settings
Sorting vectors
Panel replot
Panel size
Paneling
Panel
Panel size
1 2 3 0
4 5 6 .
7 8 9 C
5
5
cm
Panel size
1 2 3 0
4 5 6 .
7 8 9 C
5
5
cm
Sorting vectors
Panel replot
Panel size
Paneling
Panel
Tool