S One
User’s Manual
OPOS
3-4
Normally the OPOS sensor registers all the marks before it starts cutting. However, with long
jobs that can result in extensive back and forward feeding of the media, this could result in bad
tracking. To avoid this, an extra parameter can be set in the cutter. With this option, the job
can be divided into panels to avoid moving the media unnecessarily. When OPOS panelling is
activated, all cut data will be cut in panels. The size of the panel will be the distance between
the OPOS marks in the X-axis.
OPOS Panels can be set to OFF, ON (2 marks) or ON (4 marks). When set to ON (2 marks), the
cutter will only load 2 marks in the X-direction when loading OPOS and read the marks (4 in
total for the first panel). The following panels will then be cut after reading the marks at the
end of that panel (so 2 for each following panel). When set to ON (4 marks), the last marks of
the previous panel are re-read. This improves the connection between the panels.
NOTE:
Do not use software panelling when using OPOS panelling.
Activating OPOS panelling:
1.
Power on the cutter and load the media.
2.
Press Settings.
3.
Scroll down with the arrow
and press Configuration.
4.
Press OPOS parameters.
5.
Press OPOS panelling.
6.
Select 2 or 4 marks.
7.
Press
to confirm.
S1D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
FlexCut
Tool
Actions
Settings
Calibrations
Configuration
Ethernet
Wi-Fi
USB Port
Language
Menu units
OPOS Parameters
Configuration
OPOS origin
OPOS panelling
OPOS sheet mode
OPOS parameters
On (4 marks)
Off
OPOS panelling
On (4 marks)
Off
OPOS panelling
3.2.3
Processing long jobs