Introduction
1-1
1
SETUP
The purpose of the user’s manual is not only to explain the operating procedures of this
machine, but it also provides the owner, users, and operators with precaution procedures for
safe and proper machine operation for its intended purpose. All information in this manual
must be read and understood before any attempt is made to operate the machine.
The manufacturer has no direct control over the machine operation and application. Proper
safety practice is the sole responsibility of the owner, user, and operator. All instructions and
safety warnings in this manual are based upon the use of this machine under proper operating
conditions without alterations from the original design.
Any use of the cutter that is beyond the capabilities of the combination knife/material is
considered as improper use and may result in injury and serious damage to the machine and
will lead to loss of warranty.
Warning with dark (red) symbol: Refers to immediate threat that can
cause serious injuries and effects on health and safety.
Warning with light (yellow) symbol: Refers to a dangerous situation
that can cause injuries and serious damage to the machine.
Attention with dark (red) symbol: Refers to useful information to
prevent damage to the equipment and prolong the service life of the
machine.
Attention with light (yellow) symbol: Refers to useful tips to enhance
the user-friendliness and make the work significantly easier.
Note: Can be considered as a general tip; something that is useful
to know.
1.1
Safety
1.1.1
General
1.1.2
Symbols used in the manual
