S One
User’s Manual
Introduction
1-6
FIG 1-2
1-2
S ONE CUTTER FRONT VIEW
1.
Pinch rollers:
The pinch rollers clamp the media to the grit rollers to ensure accurate
tracking. Larger models have one or two extra pinch rollers to ensure that wide media
stays flat in the middle. The extra rollers in the middle can be enabled or disabled.
2.
Touchscreen:
All cutter activity can be initiated from the touchscreen. It displays
information about the cutter’s current status and/or actions that need to be taken.
3.
Pinch roller lever:
This lever is used to raise and lower the pinch rollers for media loading.
4.
Media grit rollers:
The media grit rollers only move the media when the pinch rollers are
in the “down” position.
The larger the model, the more small sleeves.
5.
Tool carriage:
The tool carriage is the mount for the knife holder, pen or pouncing tool. It
also holds the Optical POSitioning sensor (OPOS).
6.
Cutting strip:
A self-healing orange strip helps avoid any damage to the knife tip when no
media has been loaded. Since cutting is done on the cutting strip, the strip must remain
intact.
7.
Media sensor:
A media sensor behind the right sleeve is used to detect the end of the
loaded media.
8.
Screws to secure the cutter base:
Make sure all screws are secured at each side before
the cutter is used.
9.
Media basket
to recover the cut material.
1.2
S One Cutter Components
1.2.1
The Cutter as viewed from the front
