S One
User’s Manual
Introduction
1-26
The S One cutters can also be operated with a kind of plotter pen. After replacing the knife with
a pen, the cutter can be used as a plotter to draw draft plots of new or existing designs on
paper.
1.
Loosen the head clamp screw and remove the tool from the clamp.
2.
Install the pen in the clamp and tighten the clamp screw.
3.
The change of tool can either be done on the touch panel, with Summa Cutter Control (PC
only) or with the cutting software.
Selecting pen operation disables the knife offset correction and changes the
pressure to “pen
pressure.”
ATTENTION:
The information on the touchscreen shows the currently selected
tool by the cutter. Make sure the cutter’s tool setting matches the actual tool in
use.
FIG 1-19
1-19
KNIFE IS CHOSEN TOOL
FIG 1-20
1-20
PEN IS CHOSEN TOOL
Knife
Pen
1.6.2
Pen installation
