S One
User’s Manual
Basic Operation
2-11
The cutting through functionality is focussed on cutting simple shapes (e.g. rectangles). It is
mostly used in combination with contour cutting.
An interrupted cutting line (small ‘bridges’) makes sure the material remains together. When
the job is finished the cut pieces can be torn out.
FIG 2-6
2-6
FLEXCUT PRINCIPLE
Some cutting software can recognize the difference between a contour line and a cut-through
line. The software will send the data of the contour lines to the cutter first, activate FlexCut,
panelling mode and vector sorting and then send the cutting through data to the cutter.
If the cutting software cannot do this, the user will have to send the data of the contour lines
separately first, set the cutter manually in FlexCut mode and then send the data for cutting
through.
Setting the parameters for cutting through the media:
NOTE:
The
following procedure describes how to set the parameters for FlexCut.
The parameters used are 180 gr and 10 mm for full pressure, 100 gr and 1 mm
for FlexCut pressure and auto speed as an example. Section 2.6.2.2 describes
how to get the exact parameters for the media that you will be using.
1.
Power on the cutter and load the media.
2.
Press
.
3.
Press FlexCut.
4.
Select the parameter to set.
Cutting Length
Flex Length
Full Pressure
Flex Pressure
Media
Cut
Not cut
S1D160
50000 x 145 mm
Knife
700 mm/s
90 g
Configuration 1
LAN 192.168.10.2
Knife pressure
Knife offset
FlexCut
Tool
Actions
Settings
Full pressure
Full pressure cut length
Flex pressure
Flex pressure cut length
FlexCut mode
FlexCut Velocity
FlexCut
2.6
Cutting through
2.6.1
Procedure
