S One
User’s Manual
Basic operation
4-4
FIG 4-3
4-3
SETTINGS MENU
Velocity is the bundled parameter to change the speed of the tool/media. This parameter is
explained in section 2.3.
The Overcut submenu enables you to generate an overcut to facilitate weeding the cut. Each
time the knife goes up or down, the cutter cuts a bit further.
The overcut setting can be disabled (=0) or set to any value between 0(=off) and 10. One unit
is about 0.1 mm or 0.004 ".
FIG 4-4
4-4
OVERCUT
Section 2.2.3 explains how to change the overcut value.
OptiCut increases the cutting quality in case the knife is worn out or not calibrated correctly.
OptiCut is default set to OFF.
Press OptiCut, then after pressing On or Off, press
to confirm or
to cancel.
TurboCut increases throughput without raising the overall speed of the plotter by speeding up
the drag movement. The cutting time reduction is significant, especially when cutting small,
detailed designs. However, some thicker materials might not be cut properly when this feature
is activated.
Press TurboCut, then after pressing On or Off, press
to confirm or
to cancel.
Velocity
OptiCut
Panel
TurboCut
Overcut
Settings
4.4
Settings menu
4.4.1
Velocity
4.4.2
Overcut
4.4.3
OptiCut:
4.4.4
TurboCut: