SummaCut cutter
User’s Manual
Setup
1-16
NOTE:
If the flanges are not used (not recommended – tracking is not guaranteed), then
make sure that the roll is caught between the two flange guides.
FIG 1-19
1-19
FEEDING ROLL MEDIA WITHOUT USING MEDIA FLANGES
5.
Start feeding the media from the rear of the machine. Pass the media underneath the
pinch rollers towards the front of the machine.
6.
Position the left media edge on the left-most drive sleeve and check whether the right
media edge is positioned over the long drive sleeve. Then position the left and right
pinch rollers.
The pinch rollers should be positioned over the drive sleeves about 3 to 15 mm (0.1” to
0.6”) away from the media’s outer edges (1). Then pull on the media while holding the
flange at the back so the media is tight.
FIG 1-20
1-20
MEDIA POSITION
In circumstances where the above procedure does not work, because the media is too
narrow to reach the long drive sleeve, try positioning the left media edge over the
second left drive sleeve and position the right media edge somewhere over the long
drive sleeve. Continue moving the left pinch roller toward the long drive sleeve until
both pinch rollers are in their designated position and directly over the edges of the
vinyl.
In all cases, both edges of the media must cover a drive sleeve. If this is not the case,
reposition the roll of material to cover the drive sleeve.
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
