SummaCut cutter
User’s Manual
Setup
1-20
1.6
Tool Installation
SAFETY WARNING
: The SummaCut cutters use razor-sharp knives. To avoid serious injury,
use caution when installing, removing or otherwise handling the knife!
1.6.1
Knife installation
A knife has been pre-installed in the cutter.
For safety reasons, the knife depth has been set to zero. Simply turn out the knife (see fig 1-
22 yellow arrow clockwise) to start cutting. Below is the complete description of the knife
removal and knife installation.
¾
Removing the drag knife
1.
Loosen the head clamp screw (1), swing the clamp arm back and remove the knife
holder from the clamp (2).
FIG 1-22
1-22
REMOVING THE DRAG KNIFE HOLDER FROM THE CLAMP
2.
Turn the knurled adjustment knob (3) clockwise to push the knife (4) out of the holder
(5).
FIG 1-23
1-23
REMOVING THE KNIFE FROM THE STANDARD DRAG KNIFE HOLDER
3.
Carefully pull the knife from the holder.
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
