SummaCut cutter
User’s Manual
Detailed Operation
4-2
4.2.1
Velocity
Velocity is the bundled parameter to change the speed of the tool/media. This parameter is
explained in section 2.3
4.2.2
TurboCut
TurboCut increases throughput without raising the overall speed of the plotter by speeding
up the drag movement. The cutting time reduction is significant, especially when cutting
small, detailed designs. However, some thicker materials might not cut well with this
feature turned ON.
Press the button, then use
or
to activate or deactivate TurboCut.
Press
to confirm or
to cancel.
TurboCut is default activated.
4.2.3
Pressure
Pressure is preceded by its tool name. This parameter is explained in section 2.2.2
4.2.4
Knife offset
This parameter is explained in section 2.2.3
4.2.5
Pouncing Gap
The pouncing gap submenu is used to set or modify the distance between the pounced
holes. The default pouncing gap value is 1 mm.
After pressing the
key, press the
or
jogging key until the desired pouncing
gap is displayed on the LCD and press
to confirm.
The value can be set between 1 mm and 50 mm.
4.2.6
User Config.
The SummaCut cutters include 4 user configurations, all of which consist of the same
parameters. Each configuration can have unique parameter settings. This allows the cutter
to be quickly and easily reconfigured for different types of jobs or media. This parameter is
explained in section 2.2.2
4.2.7
Reset
The RESET instruction performs a complete reset of the cutter. Press the
key to
execute a reset.
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
