SummaCut cutter
User’s Manual
Detailed Operation
4-9
4.3.12
Parity
The PARITY submenu is used to set or modify the byte format and parity type for serial
communications between the cutter and the host computer.
There is the choice between None, Mark, Even, and Odd.
NOTE:
If the cutter’s parity setting does not match the setting of the computer, then
communication between cutter and computer will be erratic or will not work at all,
depending on the commands the cutter receives.
Press
, then use
or
to change. Press
to confirm or
to cancel.
The parity is default set at None.
4.3.13
RTS/DTR (RS232):
This parameter controls the “handshake” between cutter and computer.
Possible settings are Toggle or Always High.
NOTE:
If the RTS/DTR setting of the cutter does not match the setting of the computer, then
communication between cutter and computer will not work when large packets of data are
sent from computer to the cutter. A typical fault in this setting is a job that begins without
any problem and then suddenly stray lines are cut out (or drawn).
Press
, then use
or
to change. Press
to confirm or
to cancel.
RTS/DTR is default set to Toggle.
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
