Service Manual
SummaSign
REPLACING THE Y-BELT
To replace the belt, proceed as follows:
115.Remove the left-hand cover (
see
Chapter 2. 1, Removing the left-hand cover).
116.Remove the right-hand cover (
see
Chapter 2.2, Removing the right-hand cover).
117.Remove the 2 screws holding the belt against the carriage plate. One is located to the left of the
head and the other to the right.
118.Remove the belt.
To re-install, proceed as follows:
119.Screw one end of the belt firmly against the carriage plate.
120.Put the belt around the left-hand pulley. Pull it along the length of the unit and put it around the
right-hand pulley.
121.Screw the other end of the belt firmly to the carriage plate.
122.Proceed in the reverse order of removal. Make sure to firmly tighten all screws.
72.
Note:
73.
Because the belt is equipped with a springload system, the belt tension need
not be adjusted.
123.
REPLACING THE CUTTING STRIP
To replace the cutting strip, proceed as follows:
124.Loosen the cutting strip on the left-hand (or right-hand) side .
125.Gently pull the cutting strip out of the strip slot.
126.Cut the new cutting strip to the correct length and stick it to the unit.
127.
74.
Note:
75.
The newer models all have cutting strips with the tape included. There are two
cutting strips. They have the following part numbers:
76.
391-386 for all the models 500/610 and 750;
77.
391-886 for all the models 1010 and 1300.
78.
79.
Caution:
80.
In older models, the strip is glued to the unit. To replace it with the new type of
strip, proceed as follows:
81.
1. Loosen the strip on the left-hand (or right-hand) side.
82.
2. Place a chisel under the strip and move gently along the length of the unit.
83.
3. Remove any debris and thoroughly clean the strip slot.
128.
129. Cut the new strip to the correct length and stick it to the unit.
Replacement Guidelines
2-29
Summary of Contents for SummaSign D1010
