SummaSign Pro SL D-series Cutters
User’s Manual
General Information
1-20
1.7.3
INSTALLATION OF THE POUNCING TOOL
The SummaSign Pro SL cutters can also be operated as pouncers by replacing
the knife with a pouncing tool.
Î
To install the pouncing tool, proceed as follows:
1.
Loosen the clamp screw and swing the clamp arm back. Remove the
knife holder or pen (refer to Fig 1-6).
2.
Install the pouncing tool, close the clamp arm, and tighten the screw.
3.
To configure the machine for pouncing operation, press the
key.
Selecting pouncing operation disables the knife offset correction and
changes the tip pressure from knife pressure to pouncing pressure.
