SummaSign Pro SL D-series Cutters
User’s Manual
Operation
2-5
MENU
DESCRIPTION
USER CONFIG 1 (->4)
Selects a given active cutter configuration from one
of the four sets of configuration parameters stored in
the cutter's memory
INTERNAL TEST
Activates one of the resident cutting plots provided
for informational purposes.
TABLE 2-1:
CONTENTS OF THE SUMMASIGN PRO SL D-SERIES MENUS
2.1.5
THE ENTER KEY
The
key (ENTER) is used to select the item currently displayed on the LCD.
2.1.6
THE 1 AND 2 KEYS
1 - 2
The use of the
1
and
2
keys varies according to the operation in progress; their
use is displayed on the LCD as appropriate.
2.1.7
THE JOGGING KEYS
Use of the jogging keys varies according to the operation in progress.
For example, when working in the USER CONFIG menu, the
or
jogging
key is used to select the new user number and the
or
jogging key is used
to go to the previous or next menu item.
2.1.8
THE TOOL UP/DOWN KEY
The
key (TOOL UP/DOWN) is used while the cutter is offline to raise or lower
the tool. Pressing the
key once will lower the tool onto the media. Pressing
the
key again will raise the tool.
If the tool is not moved for approximately eight seconds, it will be raised
automatically.
2.1.9
THE TOOL SELECT KEY
The
key (TOOL SELECT) is used to select knife, pen or pouncing operation. To
temporarily change the tool, press the key, then press the
or
jogging