SummaSign Pro SL D-series Cutters
User’s Manual
Operation 2-22
2.6
SYSTEM TESTS
The SYSTEM TESTS submenu consists of a special set of procedures that are not
required for normal cutter operation. Field service personnel, however, will
occasionally use the SYSTEM TESTS menu. When in SYSTEM TESTS, the cutter is fully
operational and performs as described in this manual.
2.6.1
LANGUAGE
The MENU LANGUAGE submenu is used to set or modify the dialogue language
on the LCD. Press the
or
jogging key until the desired language is
displayed on the LCD. Press
to apply the new setting.
The information on the LCD can be displayed in English, French, German,
Spanish, Italian or Dutch.
2.6.2
ROM REVISION
Press the
key to view information about the cutter’s ROM revision. This
information is often helpful to technicians when diagnosing problems over the
telephone.
2.6.3
SERVICE PLOT
The SERVICE PLOT provides information about the cutter, which is helpful when
requesting service. The SERVICE PLOT is always plotted at the same size and
should be performed with a pen on paper.
The plot shows the cutter’s model number, the revision numbers of the installed
Read Only Memory (ROM) circuits, the selected baud rate, the resolution, and
the buffer (memory) size.
CAUTION
The following test procedures are normally restricted to Summa Field
Service Personnel.
