SummaSign Pro SL T-series Cutters
User’s Manual
General Information
1-29
FIGURE 1-17:
FEEDING ROLL MEDIA WITHOUT USING MEDIA FLANGES
4. Make sure that the media follows a straight path from the roll to the cutting
area. This can be accomplished by sliding the media guides left and right
as needed along the media support rollers.
5. The pinch rollers should be positioned over the drive sleeves and about 3 to
15 mm (0.1” to 0.6”) in from the edges of the media.
FIGURE 1-18:
PINCH ROLLER POSITIONING
6.
Lower the pinch roller lever to press the media firmly against the drive
sleeves. After one second the tool carriage automatically moves from
the right to the left to sense the usable media width.
Use the first holes when
using rolls without media
flanges
