SummaSign Pro SL T-series Cutters
User’s Manual
General Information
1-6
1.2.3
KNIFE, BALLPOINT PEN, AND POUNCING TOOL
The SummaSign Pro SL cutters are supplied with two standard knives (for vinyl
media), one masking stencil knife, one drag knife, and one black ballpoint pen.
Tangential Knife
Medium
Quantity
supplied
Standard knife
(requires a standard knife holder along
with a standard
grey
nose piece)
standard, reflective &
fluorescent vinyl types
2 off
1 off
Double tip knife for high-density
reflective materials
(requires a standard knife holder)
high-density reflective
vinyl types
optional
Knife for masking stencils
(requires a standard knife holder along
with
black
nose piece)
masking stencils &
thick materials
1 off
1 off
Drag Knife
Standard drag knife
(requires a drag knife holder)
standard, reflective &
fluorescent vinyl types
1 off
1 off
Pen
Color
Quantity
Ballpoint pen
(requires a ballpoint pen holder)
black
1 off
1 off
Pouncing Tool
Paper
optional
TABLE 1-3:
SUMMASIGN PRO SL T-SERIES KNIVES, PENS AND POUNCING TOOLS
To order replacement knives, pens, and/or pouncing tools, contact your local
dealer, quoting the part numbers listed in table 1-9.
The SummaSign Pro SL cutters will only perform according to specifications if a
genuine Summa knife, pen or pouncing tool is installed. Do not replace the
standard knife, pen or pouncing tool with products from other manufacturers.
1.2.4
INTERFACE
Communication
USB ver 1.1, standard asynchronous RS-
232-C and Centronics parallel interface
USB : I/O Port connector
USB series “B” receptable
Mating connector
USB series “B” plug
Serial : I/O Port connector
DB-9P
Mating connector
DB-9S
Byte format
8 data bits, 2 stop bits, no parity
Baud rate
38400, 19200, 9600, 4800, 2400 bps
Parallel : I/O Port connector
Centronics female
Mating connector
Centronics male
TABLE 1-4:
SUMMASIGN PRO SL T-SERIES INTERFACE SPECIFICATIONS