SummaSign Pro SL T-series Cutters
User’s Manual
General Information
1-16
1.6
INSTALLATION OF A KNIFE, BALLPOINT PEN OR POUNCING TOOL
1.6.1
INSTALLING A STANDARD TANGENTIAL KNIFE
!
SAFETY WARNING
Your cutter uses razor-sharp knives. The knife blades may cause
serious personal injuries if handled without proper care. Use extreme
care when operating the cutter and when installing, removing or
handling the knife!
Î
To set up your cutter for TANGENTIAL knife operation, proceed as follows.
1.
As shown in Figure 1-4, insert the standard knife blade (p/n 390-549) into
the knife holder. Make sure the knife blade is firmly fixed in the holder. The
knife is inserted correctly if it cannot be removed manually from the knife
holder.
To remove an inserted blade, push against the back of the blade with the
tip of a flat screwdriver. The blade will then pop out of its holder.
This procedure also applies to the installation of the optional double tip
blade (p/n 390-551).
FIGURE 1-4:
BLADE ASSEMBLY
2. Insert
the
grey
nose piece as shown in Figure 1-5 until it clicks into place
inside the nose piece holder.
